Get out about 10 to 15 feet of hog casings and soak them in warm water. If you don’t trust your source, run water through them to check for punctures or weak spots.
Cut the venison and pork into chunks that will fit into your grinder. Mix with the salt, sugar, and curing salt (Instacure No. 1) and refrigerate overnight. Doing this helps the sausage bind to itself later. You can skip the overnight rest, but your sausage will not be as firm in the casing.
When you are ready to make the sausage, freeze your grinder’s grinding plate and blades, and the bowl you will put the meat into for 30 minutes to an hour. Do the same for the meat and fat. When everything’s nice and cold—no warmer than 38°F — mix the meat and fat with the powdered milk and all the spices.
Grind it all through a coarse plate; I use a 7 mm plate. Test the temperature of the mixture, and if it’s 35°F or colder, go ahead and grind half the mixture again through a fine die, like a 4.5 mm or some such. Set it back with the rest of the ground meat mixture. If it’s warmer than 35°F, put the mix back in the freezer to chill. This might take an hour or so if you’ve let the meat warm up too much. Use the time to clean up.
Once the sausage has been ground twice, test the temperature again to make sure it’s 35°F or colder. I prefer to chill the mix down to 28°F to 32°F for this next stage. Chill the mix and when it’s cold enough, take it out and add the beer. Now, mix and knead this all up in a big bin or bowl with your (very clean) hands for a solid 2 minutes — your hands will ache with cold, which is good. You want everything to almost emulsify.
Stuff the sausage into hog casings rather loosely. Do this in a coil before you make the links. I like this sausage in links of about 6 to 8 inches long, but it’s your choice. To twist them into individual sausages, tie off one end of the coil you just made. Pinch off links with your two hands and roll the link between them forward a few times. Move down the coil and repeat, only this time roll backwards a few times. Repeat until you do the whole coil.
Now look at the links, which will probably have air pockets in them. Use a sterile needle or sausage pricker (set it aglow in your stovetop flame) to puncture the casing over all the air pockets. Gently compress the links together to squeeze out the air pockets and rotate the links a bit more to tighten; this takes practice.
Dry your links in a cool place for at least 24 hours and up to 3 days. I hang mine in a curing fridge set to 55°F, with about 75 percent humidity. The curing salt will protect them during this time. If you haven’t used curing salt, dry the sausage uncovered in the fridge for a day.
To smoke the links, hang in a cool smoker and let the heat come up slowly until it hits about 200°F. Smoke the links until their internal temperature hits 150°F. This may be less than 3 hours, but internal temperature is more important. As soon as the sausages are cooked, submerge them in an ice water bath until cool. Pat dry and store in the fridge.
Keep in mind that any red meat works here, from deer and elk to antelope, moose, caribou, nilgai, oryx, etc. Sheep and goats, too.
Keys to Success
You kinda want these to be fatty, so don't skimp on it. 25 percent fat by weight at least, and I prefer closer to 35 percent with this recipe.
You can play around with the spices, but not the salt. The salt and curing salt are there for food safety.
The powdered milk is there to absorb moisture, which prevents shrinkage when the sausages come out of the smoker.